Potential of secondary aerosol formation from Chinese gasoline engine exhaust

Light-duty gasoline vehicles have drawn public attention in China due to their significant primary emissions of particulate matter and volatile organic compounds(VOCs). However,little information on secondary aerosol formation from exhaust for Chinese vehicles and fuel conditions is available. In this study, chamber experiments were conducted to quantify the potential of secondary aerosol formation from the exhaust of a port fuel injection gasoline engine. The engine and fuel used are common in the Chinese market, and the fuel satisfies the China V gasoline fuel standard. Substantial secondary aerosol formation was observed during a 4–5 hr simulation, which was estimated to represent more than 10 days of equivalent atmospheric photo-oxidation in Beijing. As a consequence, the extreme case secondary organic aerosol(SOA) production was 426 ± 85 mg/kg-fuel, with high levels of precursors and OH exposure. The low hygroscopicity of the aerosols formed inside the chamber suggests that SOA was the dominant chemical composition. Fourteen percent of SOA measured in the chamber experiments could be explained through the oxidation of speciated single-ring aromatics. Unspeciated precursors, such as intermediate-volatility organic compounds and semi-volatile organic compounds, might be significant for SOA formation from gasoline VOCs. We concluded that reductions of emissions of aerosol precursor gases from vehicles are essential to mediate pollution in China.     

Effect of TiO2 nanoparticle aggregation on marine microalgae Isochrysis galbana

TiO_2 nanoparticles(NPs) could adversely impact aquatic ecosystems. However, the aggregation of these NPs could attenuate this effect. In this work, the biological effects of TiO_2 NPs on a marine microalgae Isochrysis galbana were investigated. The aggregation kinetics of TiO_2 NPs under different conditions was also investigated to determine and understand these effects. Results showed that, though TiO_2 NPs had no obvious impact on the size and reproducibility of algal cells under testing conditions, they caused a negative effect on algal chlorophyll, which led to a reduction in photosynthesis. Furthermore, fast aggregation of TiO_2 NPs occurred under all conditions, especially at the pH close to the p Hzpc. Increasing ionic strength and NP concentration also enhanced the aggregation rate.The aggregation and the following sedimentation of TiO_2 NPs reduced their adverse effects on I. galbana.     

水环境综合整治工程存在的风险因素分析研究

水环境综合整治工程存在的风险因素主要有财务风险、造价预测偏离风险、征地困难风险、施工事故风险以及后期质量可靠性风险等,根据风险因素构建评价解释变量和控制变量模型,结合内部控制和信息披露方法进行风险预测评估,采用分组样本检验方法进行水环境综合整治工程风险因素方法,采用T检验方法进行水环境质量可靠性检验,实现风险有效评估和预防。通过实证分析方法进行模板数据分析,提高对水环境综合整治工程存在的风险因素的定量评估能力。     

爆炸螺栓分离对热防护系统冲击响应分析

目的考察在爆炸螺栓分离过程中,作用在TPS(热防护系统)上的冲击响应是否会导致其破坏,从而影响航天器飞行安全,对过程进行数值仿真分析。方法提出四阶段仿真方案,基于MSC.Dytran软件,采用流固耦合方法对爆炸螺栓分离过程进行动力学仿真;根据单个爆炸螺栓地面分离试验的结构进行建模和分析,获取结构响应曲线;再根据实测的冲击响应数据,对爆炸过程中炸药及JWL方程的参数等设置进行调整,获取准确爆炸螺栓的分析模型;最后应用于对真实结构中TPS(热防护系统)在分离过程里受爆炸螺栓冲击响应的动力学分析与评估。结果通过参数调整,获得的仿真模型与爆炸螺栓地面分离试验实测结果一致,证明了仿真模型的有效性和四阶段仿真方案的可行性。结论提取的真实结构爆炸螺栓分离过程中作用在TPS(热防护结构)上的最大加速度响应曲线,可用于指导TPS(热防护系统)的设计。     

重庆九龙坡城区和城郊大气污染物浓度特征研究

为了解重庆市九龙坡区城区和城郊大气污染物浓度特征,分析了城区和城郊国控空气站点2014年3月~2015年2月典型污染物的浓度变化。结果表明,除O_3表现出夏高冬低的季节变化趋势外,其它污染物均表现出冬高夏低的季节变化趋势。PM_(2.5)污染最严重,城区和郊区日均值超标率分别为31.4%和33.4%。城区和城郊的PM_(2.5)浓度之间没有显著性差异(p0.05),城郊O_3浓度显著高于城区(p0.01),NO_2、SO_2、CO和PM_(10)则是城区显著高于城郊(p0.01)。     

渤海大气气溶胶元素组成及物源分析

利用电感耦合等离子体-光发射光谱法(ICP-OES)分析了2000年夏季渤海大气气溶胶样品,给出了渤海气溶胶污染物浓度分布特点,结合气象资料和富集因子进行了元素物源分析.分析结果表明,辽东湾的污染程度高于其他海区,气溶胶中含量最高的元素是Zn(1638ng/m3),含量最低的是V(2ng/m3).渤海气溶胶中Pb、Zn、Cu和Ni等具有较高的富集因子.辽东湾Pb的富集因子达4000以上,Zn的富集因子普遍大于其他海区.Pb、Mn、Cu、V等含量的相对大小与同期北京的分析结果一致.综合分析表明,渤海大气严重受到陆地人为排放污染物的影响.     

上海汽车制造业涂装废气VOCs排放特征

于2015年10月对上海市嘉定区4家(A、B、C、D)汽车制造企业涂装废气ρ(VOCs)和组成特征进行了调查分析。结果表明,A、B、C、D厂涂装废气排放口ρ(VOCs)总为0. 743～6. 11 mg/m~3,主要检出物和最高检出值分别为:A厂二甲苯2. 06 mg/m~3、B厂二甲苯0. 578 mg/m~3、C厂甲苯2. 59 mg/m~3、D厂庚烷0. 274 mg/m~3;芳香烃类是A、B、C厂排放比例最高的VOCs组分,烷烃类是D厂排放比例最高的VOCs组分。指出,原、辅料种类影响排放物的主要成分,废气处理工艺类型影响排放物主要成分和浓度。     

多介质环境目标值的应用

本文概述了多介质目标德的SAM/Ⅰ的方法。多介质目标值包括环境目标值和排放目标值。点源分析包括SAM/ⅠA,SAM/ⅠB,SAM/Ⅰ,SAM/Ⅱ。在缺少环境质量标准的情况下,使用多介质环境目标值有较强的适用性,且具有省时、省力、经济等特点。本文将多介质目标值的SAM/ⅠA点源分析方法引入聚氯乙烯生产废水的环境评价中,取得较为满意的结果。     

土壤中的铅对三种蔬菜的影响

通过温室栽培萝卜、青菜和莴苣,研究土壤中的铅对蔬菜生长的影响及其在器官中的残留。在低浓度下,铅对蔬菜生长有不同程度的刺激作用。土壤有效态铅浓度与蔬菜各器官含铅浓度存在显著性正相关(P<0.05)。不同蔬菜对铅的敏感性、耐受力不同。     

杭州市大气NOx来源及控制对策研究

采用定常高斯模式和Thlong程序建立NOx污染源强与大气NOx浓度间定量响应数值模型,计算了点源、面源和流动源等各类污染源对杭州市区各关心点NOx的平均贡献率,分别约为17%,17%和66%,其中市区机动车尾气贡献率高达50%左右,是首先要控制的污染源.同时提出NOx排放削减方案及实施后大气NOx质量改善状况,为环保管理部门削减NOx污染源提出供决策参考.